What is the code U111300 on Audi?
More specifically, U111300 could suggest a problem related to CAN bus communication failure, which is the system that allows the various control modules (like the engine control unit, airbag control unit, etc. This issue could be caused by: A faulty sensor. U1113 is a communications fault. Normally fault is thrown when a module doesnt see a signal it likes or sees as a valid signal. Clearly states some sort of issue with FC signal. IIRC FC signal is related to fuel injectors.A software error when writing component protection data can lead to Over the Air – Function Controller (OTA-FC) fault code U110100, “Component protection active.
What is the code U111300?
The U111300 code you’re seeing indicates a communication error within the vehicle’s network. More specifically, U111300 could suggest a problem related to CAN bus communication failure, which is the system that allows the various control modules (like the engine control unit, airbag control unit, etc. This issue could be caused by: A faulty sensor.
What is the code U111200 on Audi?
The error code U111200 is related to the missing message from the Vehicle Dynamics Control Module VDCM. This code is specific to Audi vehicles and is not a generic trouble code. It sounds like you’re dealing with error code U111300 on your Audi A4, which points to a Function limitation due to received malfunction value. Since this started a week ago and you’re experiencing fuel cuts at wide open throttle, it could be related to a communication issue between control modules or a sensor .
How do I fix error code P0101?
How to fix the P0101 code. To start, you’ll need to check the wiring and connections between the MAF sensor and the ECU (Engine Control Unit), then replace any faulty parts. If all of this checks out okay, it’s likely that you’ll need to replace your air filter. What Is the P0101 Code? Can I Still Drive? Error code P0101 indicates that there is an issue with your mass airflow sensor (MAF). In this case, the MAF is out of its intended range.How to fix the P0101 code. To start, you’ll need to check the wiring and connections between the MAF sensor and the ECU (Engine Control Unit), then replace any faulty parts. If all of this checks out okay, it’s likely that you’ll need to replace your air filter.The P0101 code indicates that there’s an issue with the Mass Airflow Sensor (MAF) in your Chevy. It can be caused by a faulty MAF sensor, a dirty or clogged air filter, vacuum leaks, faulty wiring or connections, or a failed PCM/ECM.Use CRC’s Air Sensor Clean Pro with the engine off. Unplug the MAF wiring harness. Removing the sensor is recommended for best results, but it’s not necessary.